The oi010 is a combination of a 2 Channel RF I/O module (FMC30RF) and the EMC²-DP.

As such this system gives you fully featured Rx / Tx module on a one bank PC104 FPGA carrier card.

Key points of the I/O module:

  • Conduction cooled compatible
  • ANSI/VITA 57.1-2010 compliant
  • RF coverage from 400Mhz to 3.0GHz*
  • Time Domain Duplex (TDD) and Frequency Domain Duplex (FDD) compatible
  • Low Power, Small Footprint
  • Complete transceiver signal chain solution for up to 60MHz* bandwidth
  • Dual DAC, IQ modulator for Tx
  • Dual ADC, IQ modulator with PGA, buffer and filters for Rx
  • On-board clocking with integrated PLL/VCO
  • LNA front-end
  • LPC (Low-Pin Count) 160 pins connector
  • Phase locking for clocks and RF between two boards
  • MIL-I-46058c compliant (optional)

Key points of the carrier:

  • PCIe/104 OneBank Carrier for Trenz SoC Modules
  • PCI Express Gen 2 compatible and integrate PCI Express switch
  • Infitive number of EMC²-DP can be stacked for large I/O solutions
  • Expandable with any VITA57.1 FMC I/O Module for more flexibility
  • 96mm x 90 mm PC/104 Form-Factor with Cable-less Break-Out PCB Connector

The oi010 needs to be coupled with the FPGA module of your choice.  Depending on the application you are designing for, we have a range of FPGAs to suit.

They are all based on the Trenz 5×4 System on Module standard, including Artix, Zync, Kintex and Kintex UltraScale FPGAs

For more information on these modules, please see out SoM Systems please see our range here: SoM Range.

OI010